High Definition Digital Screen Burning

We recommend using Green Blockout Tape when you need to tape off a screen with multiple images or for covering pin holes that might appear while printing.

Tru Blue Painters tape can also be used for smaller quantity print runs.

To tape off sections of the screen that won't be used during a print run, simply apply the necessary amount of tape to fully cover the image you aren't currently printing. This is common when printing with a single screen that has both a pocket print image and front or back placement image. You won't need to layer the tape, just ensure all unneeded image elements are covered.

After printing, remove the excess ink and carefully peel the tape from the mesh. You might need to create a 'handle' by folding over one end of the tape so removal is easier. It is important to remove the tape after printing and before cleaning the screen so moisture and adhesive don't have time to set. Tape left on the screen for more than a few hours after printing could damage the image burn if it's removed after drying.

Once the tape is removed, follow the normal cleaning recommendations for water based or plastisol inks.

Plastisol inks are thicker than water based inks- especially white plastisol.

Before using any plastisol ink, make sure to mix it to the point where its consistency is 'creamy' in texture. If you try to print without mixing the ink to a smooth, even texture, you will have trouble pulling the ink through the mesh. To mix plastisol ink, simply use a wooden stir stick. For smaller amounts (pints, quarts) a stir stick or knife will be fine. Larger buckets of ink will require the use of a hand drill and mixing tool attachment.

You can save and reuse any residual plastisol ink you have scraped from the frames you are planning to store.